ST-TFIM Tubular Fabric Inspection Machine is specially and efficiently inspect the both sides of tubular fabric in single pass operation.When customer bought our ST-TFIM, we will give provide three different sizes of light boxes, why do we give light boxes for this machine?We will provide three different sizes of light boxes according to customers' requirements for various fabric,but the range is ...

Some customers maybe have such problem: Why the fabric selvadge is not aligned well when fabric inspection machine rewinding?Here is the answer.1) Cloth Guider:Adjust the pair of cloth guider to the optimal working condition, which could keep fabric in the center.2) Edge-alignment Photo SensorOpen the Edge-alignment Photo Sensor, which could detect fabric selvedge and allow the Rewinding Station m...

Many textile factories require the higher quality fabric to build their own brand. Therefore, the demands of Fabric Inspection Machine is increasing.Suntech Fabric Inspection Machines are installed all around the world. It is used to inspect fabric defects. As well, Suntech could provide Defect Inspection System, also named 4-points system to record the defects, shifts, batchs... The printer could...

Three sets of Scroll Roller and One set of Air-blowing device to control fabric curled edges through Fabric Inspection Machine1 Before inspection table, the scroll roller will make fabric open totally when inspection.2 After inspection, the scroll roller will open fabric curled edges again to make sure an accurate edge-align.3 Before rewinding, the scroll roller& Air-blowing device will once more ...

What is 4 Point System?4 point system is a software for recording the fabric faults, which is installed on fabric inspection machine.How to use the SUNTECH 4 Point System?First Step: Install the software into the computer and connected the computer with the machine(Usually if customer requires this system, we recommend them to buy the computer,software, printer together. We will install do the fir...

No. The complete system of ST-BS is PLC controlled and HMI (Touch Panel) is easy for operation, so there is no specific requirement for the operators.

The hand wheel could adjust the speed difference of two pulleys.The two pulleys are connected with the twin rewinding rollar separately .If there is speed difference between the two pulleys,there is also speed difference between the two rewinding rollers which could result in tight or loose fabric rolls.